Except for bench seats with split seatbacks, when the tether anchorage is used in the center seating position, the strap should be positioned straight over the top of the seatback. This prevents you from acciden- tally locking your keys in the vehicle. Push down on the wrench while tightening for increased leverage. You can strike the interior of your vehicle or other passengers, or you can be thrown out of the vehicle. You or others could be badly burned by steam or boiling coolant. Open seams or loose connections could permit exhaust fumes to seep into the passenger compartment.
No more ruining your expensive paper shop manual with grease and dirt. There are power sliding door switches located on the trim panel just in front of the power sliding door for the rear seat passengers. Position the end of your hand-held transmitter 1-3 inches 3-8 cm away from the HomeLink buttons while keeping the indicator light in view. For bench seats with split seatbacks, route the tether between the seatbacks. It can be removed from the vehicle by pulling the release handle inside the floor console.
Fluid level should be checked on a level surface and with the engine off to prevent injury from moving parts and to insure accurate fluid level reading. Inspect the engine air cleaner filter, replace if necessary. Direct sunlight or objects blocking the line of sight may affect the function of the remote control. Do only that service work for which you have the knowledge and the proper equipment. Do not remove the belts from the car to wash them. DaimlerChrysler Corporation Integrated Child Seat — If Equipped Operating instructions for this seat are included with the seat. Lights-on Reminder If the headlights or the park lights are left on, or if the dimmer control is in the extreme top position after the ignition switch is turned off, a chime will sound when the.
This allows the airbag to have different rates of inflation that are based on collision severity. Position the latch plate as close as possible to the anchor point. To keep your door operating properly, observe the fol- lowing guidelines. The engine block heater cord is routed under the hood on the driver side of the vehicle. Checking the oil while the vehicle is on level ground will improve the accuracy of the oil level readings.
Auto Door Locks When this feature is selected, all doors and the liftgate lock automatically when the speed of the vehicle reaches. Sooner or later, maintenance will need to be performed. These abnormal wear patterns will reduce tread life resulting in a need for earlier tire replacement. Inspect the engine air cleaner filter, replace if necessary. If you do not read this entire manual you may miss important information. These locations are on the sill flange of the body and consist of a pair of downstanding tabs. The instability could cause an accident.
After the bulb check or when driving, if the driver seat belt remains unbuckled, the Seat Belt Warning Light will flash or remain on continuously. Each of these outlets can be individually adjusted to direct the flow of air. These, and all other maintenance services included in this manual, should be done to provide best vehicle performance and reliability. Head restraints from one seating position should not be removed and installed in any other seating posi- tion. The traction grade is based on braking straight- ahead traction tests and does not include cornering turning performance. If the bulb begins to flash after the bulb check, this indicates that an invalid key has been used to start the vehicle. The sunroof can be stopped at any position between closed and full vent.
The Auto Door Locks feature is enabled and the Auto Unlock On Exit feature is enabled, 2. Moving the air vane knob on the center outlets down, will close off the air flow from the center outlets. The vehicle should have service performed. A slight amount of air is directed through the defrost and side window demister outlets. If your vehicle is equipped with Remote Keyless Entry, the lights will also turn on when the unlock button on the transmitter is pressed.
If you press the power door lock switch while the sliding door is open, the sliding door will lock. This device may not cause harmful interference, 2. Inspect the tie rod ends and boot seals. These numbers can be used to order duplicate keys from your dealer. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. The limited use spare tires are for emergency use only.
Seat Belts and Pregnant Women We recommend that pregnant women use the seat belts throughout their pregnancies. . Avoid touching the new batteries with your fingers. Some manuals actually cover more items that are not even listed! The key must be held in the unlocked position for the liftgate to open. In a collision, an unrestrained child, even a tiny baby, can become a missile inside the vehicle. Pressing the switch once will open the power sliding door, once the door is fully open pressing the switch a second time will close the door.