Twist the bulb socket counterclockwise and carefully pull to remove it from the lamp assembly. Ford Motor Company has not approved a slingbelt towing procedure. Cycle the ignition to the on position with the engine off. Repair warning light in use the damaged road wheel and re-mount it on the vehicle to restore system functionality. Refer to scheduled maintenance information. How to use the engine block heater Ensure the receptacle terminals are clean and dry prior to use. Turn the key to 4 start , then release the key as soon as the engine begins cranking.
Pull the lever fully again to deactivate. Refer to the Maintenance product specifications and capacities section in this chapter. Ford does not recommend disabling this feature except in situations where speed reduction may be detrimental e. To reset the oil monitoring system to 100% after each oil change, perform the following: 1. For an overheating condition, let the system cool off, then turn the ignition key off then on. Engine oil pressure gauge: Indicates engine oil pressure. Connect the negative - cable to the negative - terminal of the assisting battery.
To operate the heated seats, do the following: Press the heated seat symbol to cycle through the various heat settings and off. A memory seat position may be programmed at any time. Press and release the button again. Remove the shield by disengaging the fasteners at each corner of the shield. Turn the ignition switch to the on position. Refer to Filling the tank in the Maintenance and Specifications chapter for more information. Move the transfer case lever through N Neutral directly to the desired position.
This allows the audio from a portable music player to be played through the vehicle speakers with high fidelity. Windshield washer fluid reservoir 2. Note: Large metallic objects, electronic devices that are used to purchase gasoline or similar items, or a second coded key on the same key chain may cause vehicle starting issues. Select the desired temperature using the temperature control. Remove bulb socket from the lamp assembly by turning it counterclockwise. The turn signals will flash for as long as the lever is held in this position.
The blower will automatically go to maximum. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. Reinstall the lug nuts until the wheel is snug against the hub. This arrangement provides lap and shoulder belt protection for all occupants, and airbag protection for the adults. Purchasers have actually an option between four and two wheel drive on all variations for the F-150 except the Raptor, which has four-wheel drive as standard products. Turn off as many of the electrical loads as soon as possible to improve system voltage. To change the license plate lamp bulbs: 1.
By law, vehicle owners and anyone who manufactures, repairs, services, sells, leases, trades vehicles, or supervises a fleet of vehicles are not permitted to intentionally remove an emission control device or prevent it from working. Make sure the parking brake is set. Do not push on the button while stowing the box side step. Turn the steering wheel one-half turn to access the slots on each side of the steering wheel. Shield your eyes when working near the battery to protect against possible splashing of acid solution. If you and your friend each weigh 220 lb.
Safety belt locking modes All safety restraints in the vehicle are combination lap and shoulder belts. It also fails to make. Your vehicle has a computer assisted cranking system that assists in starting the engine. Instructions are very clear and it definitely helps you to do a job quicker and cheaper. Check your Warranty Guide to find out which parts and services are covered. Ford F150 Bull Bars give you premium looks.
Use of these systems may result in vehicle starting problems and a loss of security protection. If the needle falls below the normal range, stop the vehicle, turn off the engine and check the engine oil level. View all 2011 Ford Transit Connect models. Push seat cushion down until it locks into horizontal position. Department of Transportation-Tire quality grades: The U. Use of 4H 4X4 High on these surfaces may produce some noise such as occasional clunks , but will not damage drive components. This will definitely save you a ton of money on repair.
Use all available road surface to return the vehicle to a safe direction of travel. The Lariat provides upscale interior trim, heated eight-way power driver, fabric upholstery and power-adjustable pedals, passenger seats with power-adjustable lumbar, dual-zone automated weather controls and a power-sliding window that is rear. Press the to scroll through the following options: a. In addition, some vehicles, trims or options. For more thorough cleaning, wipe the surface with a mild soap and water solution. Information in this respect is highlighted in this guide with the tree symbol. Engine oil filler cap out of view 8.