Install the lower clevis bolt 3 at the lower control arm and tighten to 169 N·m 125 ft. Tighten the tie rod jam nut 3 to 75N·m 55 ft. The cooling system is designed around the coolant. Wheel alignment involves the correct positioning of the wheels in relation to the vehicle. This can increase cylinder head temperatures under certain conditions. X Inspect drive belt, replace if necessary.
Chisel out the ball joint stakes. X Inspect the drive belt, replace if necessary. Engine Oil - with Filter - 4. Also, a higher percentage of antifreeze can cause the engine to overheat because specific heat of antifreeze is lower than that of water. X X X Inspect the engine air cleaner filter, replace if necessary. Transmission fluid must also be a good conductor of heat.
X Drain and refill the front and rear axles. X Inspect the brake linings. X X X X Inspect the engine air cleaner filter, and replace if necessary. X Clean and lubricate the brake caliper pins. This Service Manual has easy-to-read text sections with top quality diagrams and instructions. Install the air box cover and air intake hose.
X Inspection and service should also be performed anytime a malfunction is observed or suspected. X X Drain and refill the automatic transmission fluid, and replace main sump filter 4. If not, and a jump start does work, Then it is the Battery or the post connections. Miles 3,000 6,000 9,000 12,000 15,000 Kilometers 5 000 10 000 14 000 19 000 24 000 Change the engine oil and engine oil filter, if not replaced at 3 months. Remove the four upper shock mount nuts 2. X X X X Inspect the brake linings. Jeep Chilton Repair Manual for 1984-01 covering all models of Jeep Cherokee, Grand Cherokee 1993-98 , Comanche, Wagoneer and Grand Wagoneer.
X Drain the transfer case and refill. Loose or worn steering gear. Install the rear bolts for the lower control arm to the frame, Tighten to 142 N·m 105 ft lbs. X Drain the transfer case and refill. The arms mount to the cradle bracket and the knuckle. X Clean and lubricate the brake caliper pins. The required ethylene-glycol antifreeze and water mixture depends upon the climate and vehicle operating condi- tions.
Seperate the lower ball joint from the knuckle 1 using tool C—4150A 2. If the viscosity stays constant through the temperature range of operation, transmission operation and shift feel will remain consistent. This temperature is hot enough to melt plastic and soften solder. This is for purpose of heat transfer only. X Inspect the drive belt, replace if necessary. When service is required, DaimlerChrysler Corporation recommends that only Moparா brand parts, lubricants and chemicals be used.
Answered on Oct 24, 2017. X Clean and lubricate the brake caliper pins. X Drain and refill the front and rear axle fluid. Remove the wheel speed sensor nut 2. Raise and support the vehicle. X Inspect the drive belt, replace if necessary.
X Drain the transfer case and refill. छ X Replace the spark plugs. . X X Inspect the brake linings. Install the hub bearing to knuckle and the 3 bolts then tighten to 136 N·m 100 ft. X X Inspect the brake linings.
The identifying notations are located on the front label of engine oil plastic bottles and the top of engine oil cans. X Drain and refill the front and rear axle fluid. X X X Inspect the engine air cleaner filter, replace if necessary. To maintain the camber angle while adjusting caster, move the rear of the lower control arm in or out. This coolant offers the best engine cooling without cor- rosion when mixed with 50% distilled water to obtain to obtain a freeze point of -37°C -35°F. An alignment is considered essential for efficient steering, good directional stability and to minimize tire wear.